![\"transverse-tarmac-cracking\"](\"http:\/\/mocktheorytest.com\/resources\/wp-content\/uploads\/2013\/10\/transverse-tarmac-cracking.jpg\")
<\/p>\nTwo-wheeled vehicles are much more unstable than four-wheeled vehicles on inconsistent road surfaces. It’s impossible for our roads to be 100% perfect at all times which is why it’s important for motorcyclists to scan the road ahead. Whether you’re just learning to ride or you’ve been riding a while, being able to recognise these ten different types of problematic road surfaces could save your life.<\/p>\n
<\/p>\n
If you run off the sealed roadway the road shoulder should provide a safe area in which you can recover. If they are broken or contain gravel areas it reduces the ability for the rider to retain control, especially when making corrective manoeuvres or braking heavily.<\/p>\n
Line marking on the edge also helps delineate where the good road surface ends and the poorer quality surface begins when the light levels are lower or visibility is poor.<\/p>\n
![\"pot-hole-with-puddle\"](\"http:\/\/mocktheorytest.com\/resources\/wp-content\/uploads\/2013\/10\/pot-hole-with-puddle.jpg\")
<\/p>\n
Check out our guide to potholes and tarmac degradation here<\/a>. A pothole causes a sudden change to the bike’s suspension loading. This can be damaging to the suspension components or could cause a burst tyre. It also unsettles the rider and can interfere with braking performance. Even badly repaired potholes can cause dangers for motorcyclists.<\/p>\n This is never usually a problem in city areas where there is plenty of traffic, but on infrequently used rural roads moss and lichen can build up on the edges and in the centre of the lane. When wet, this surface is much more slippery than normal wet tarmac. Moss and lichen also break down the pavement surface leading to quicker degradation.<\/p>\n In areas with softer substrates coupled with heavy vehicles and soil subsidence, ruts and corrugations can form. In a car, these can cause tramlining, or the tendency for the vehicle’s wheels to want to follow the rut. On a motorbike, the same thing can happen where the ridges and edges of a rut can change the bike’s direction unexpectedly.<\/p>\n Shoves happen where the tarmac slips over the substrate. In any of these cases, water collects in the tarmac’s degraded areas.<\/p>\n Sometimes cracks are sealed and in areas where a lot of sealant is used this can create a slippery surface in the rain.<\/p>\n In hot weather, the tar can bleed to the surface creating a sticky and slippery layer. When this sets again it ends up being polished to a surface that has less friction.<\/p>\n Where the road has been repaired improperly and chip loss is occurring, these areas need to be addressed as the lack of pavement texture causes slippery patches.<\/p>\n Older markings that don’t use skid-resistant paint can be dangerous in the wet. Avoid them on corners and at junctions. Newer paint has excellent skid resistant properties, but it’s still good to be in the habit of avoiding them.<\/p>\n Trees drop a lot of leaves in autumn and this creates a slippery mush when it’s wet. Vegetation can also shade some corners from the sun, preventing them from drying or thawing.<\/p>\n During heavy rain and storms stones, vegetation, glass and other detritus can wash or be blown into areas of the road, particularly the apex of cambered corners where you might be tempted to cut. Gravel, mud and stones can be washed from unsealed driveways and farm entrances. Spillages from trucks and farm equipment can cause areas that are slippery.<\/p>\n When the weather has been dry a while rubber, grease and oil build up on the road, and when it first rains this creates a very slippery surface.<\/p>\n Some roadworks will use large temporary steel plates. Newer plates tend to be textured or covered in skid-resistant material, but don’t take it for granted.<\/p>\n Where services have been laid into the road in a narrow trench, such as telephone cables, the trenches are often overfilled to allow for compaction and subsidence over time. When just filled the surface sits proud of the road and causes a bump.<\/p>\n The metal rails are very slippery when wet. Special care should be taken if your motorbike has narrow tyres to avoid them getting caught in the grooves.<\/p>\n In an accident there will possibly be broken glass and plastic, fluids spillages, soil or gravel dragged onto the road, and potentially damage to the surface. Ride with caution at accident sites.<\/p>\n If you come across these types of road surface unexpectedly you might have to ditch your bike (or have no choice). In this case, you must be wearing proper protective clothing as clothes like jeans will shred in a second, then it’s your skin versus the tarmac.<\/p>\n This article explains how to choose motorbike protective clothing<\/a>. As well as strong outerwear, body armour will protect your back chest, and buying a helmet<\/a> with an excellent crash test rating<\/a> will reduce the risk of head injury.<\/p>\n It’s best not to scrimp on your protective clothing as a spill at 50mph can cause significant injuries. As a vulnerable road user, you should be scanning<\/a> as far ahead as possible to spot these potential hazards early so that you can take evasive action.<\/p>\n","protected":false},"excerpt":{"rendered":" Two-wheeled vehicles are much more unstable than four-wheeled vehicles on inconsistent road surfaces. It’s impossible for our roads to be 100% perfect at all times which is why it’s important for motorcyclists to scan the road ahead. Whether you’re just…<\/span><\/p>\nMoss and lichen build-up<\/h2>\n
![\"narrow-lane-wales\"](\"http:\/\/mocktheorytest.com\/resources\/wp-content\/uploads\/2013\/10\/narrow-lane-wales.jpg\")
<\/p>\nCorrugations, shoves, parallel grooves and ruts<\/h2>\n
![\"tarmac-compression-puddles\"](\"http:\/\/mocktheorytest.com\/resources\/wp-content\/uploads\/2013\/10\/tarmac-compression-puddles.jpg\")
<\/p>\nCrack seals<\/h2>\n
![\"block-cracking-in-tarmac\"](\"http:\/\/mocktheorytest.com\/resources\/wp-content\/uploads\/2013\/10\/block-cracking-in-tarmac.jpg\")
<\/p>\nTarmac bleed and polished surfaces<\/h2>\n
Pavement surfacing<\/h2>\n
Pavement markings<\/h2>\n
Roadside vegetation maintenance<\/h2>\n
![\"leaves](\"http:\/\/mocktheorytest.com\/resources\/wp-content\/uploads\/2015\/06\/leaves-on-the-road-with-scooter-600x450.jpg\")
<\/p>\nRoadside debris<\/h2>\n
Grease and oil build-up<\/h2>\n
Temporary steel plates<\/h2>\n
Services trenches<\/h2>\n
Railway crossings<\/h2>\n
Accidents and spillages<\/h2>\n
Protecting yourself in the event of a fall<\/h2>\n